The simulation software is designed to give the student a detailed guided tour of the selected aircraft, during

  the inspection the software pauses at key areas (listed below) where the student must identify the required
  procedure before being allowed to continue.

  After students have completed the simulation they are then expected to carry out what they have learnt from
  the simulation on a full size scale replica fuselage including the interior.

  The WSOp(Cmn)FW software features include.....

  1. Choice of clear day or heavy snow weather settings
  2. Student to start at hangar 700 office - then commence path to desired aircraft
  3. Move to aircraft 10 o'clock position and await to start
  4. Check nose chocks
  5. Check fire extinguisher position
  6. Check GPU / APU & switches turned to 'on ready'
  7. Check GPU / APU cable connection (grounded)
  8. Check fwd stbd chocks
  9. Check along fwd stbd wing including engines
10. Check along rear stbd wing including flaps
11. Check rear stbd chocks
12. Check rear stbd door (followed by rear stbd tail)

13. Check rear tail

14. Check rear ramp

15. Check rear port tail
16. Check rear port cabin door

17. Check rear port chocks
18. Check along rear port wing including flaps
19. Check along fwd port wing including engines
20. Check fwd port chocks

21. Check pitot tubes (stbd side)

22. Check earth lead (port side)

23. Return to 10 o'clock position and face fwd cabin door

24. End inspection